ep

January 22, 2021

SMR Gearbox Set up
Satisfactory performance is determined by correct installation. lubrication and maintenance. as a result it’s important the directions while in the set up and servicing leaflet. provided with every gearbox. are followed cautiously. a number of the significant facets of belt and torque-arm installation are listed under.
one. Install pulley on gearbox input shaft as shut for the reducer attainable, and mount reducer on driven shaft as shut to bearing as practical. failure to carry out this can result in excess loads inside the input shaft bearings and output bearings and could lead to their premature failure.
2. Install motor and wedge belt drive with the belt pull at roughly 90° on the center line in between driven and input shafts. this will permit tensioning in the wedge belt drive using the torque arm which ought to ideally be in tension. if output hub runs anti-clockwise. torque arm need to be positioned the best.
three. lnstall torque-arm fulcrum on a rigid help in order that the torque-arm will likely be at about suitable angles for the center line through the driven shaft and also the torque arm situation bolt. be sure there may be sufficient consider up in the turnbuckle for belt tension adjustment.
Keep close.
Bell drive can be positioned in any hassle-free postion. in the event the torque arm will be to be utilised to tighten the belts, the drive should be at about tight angle for the line concerning the input and output shafts.
Bell drive may be located towards the correct if wanted.
If output hub rotates clock-wise. place belt drive and torque arm in opposite direction to that shown inside the illustration.
Torque arm and belt take up.
Torque arm may very well be mounted to the appropriate if sought after.