Electrical power UNITS FOR LIFT TABLE one
General Description
This electrical power unit is intended exclusively for the compact lift table,Consisting of substantial stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit continues to be extensively used inside the industry of logistic units which include minifork lift, scissors lift and ariel working platforms. The lower-ing motion is managed through the solenoid valve with the speed controlled by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Common Description
This energy unit is built solely for your medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve and also the pace controlled by the adjustable needle valve. Once the lift rises to a substantial positoin, however the power supply is cut, the lowering movement is managed through the guide override perform.
Power UNITS FOR LIFT TABLE three
General Description
This power unit is developed exclusively for your large lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve as well as the speed controlled by a stress compensated movement control valve.
Power UNITS FOR LIFT TABLE four
Basic Description
This power unit is made solely for the substantial lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve and also the speed controlled from the adjustable needle valve. When the lift rises to a substantial positoin, but the power provide is minimize, the decreasing motion is managed by the guide override perform.
Distinctive Notes
1. This electrical power unit is of S3 duty cycle, which might only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean the many hydraulic parts concerned ahead of installation of the energy unit.
3. Viscosity in the oil shoud be 15~46 cst,which need to also be clean and totally free of impurities.N46 hydraulic oil is recommended.
4. Oil transforming is required after the preliminary one hundred operation hours,afterwards as soon as just about every 3000 hours.
five. The energy unit shown is made to be mounted vertically.